Assault Cube - No Recoil - How To Find?

[Learner]

Hey guys there isn’t much tutorials on how to find the recoil address. Can someone tell me how to find it?

I have scan for current bullets, shoot and scan again. I get the ammo value. Now I go into the memory view and mess around with the values and I just try find the recoil address but cannot find it at all? I managed to only find time in between shots and rapid fire. But no sight of recoil. Does anyone know where I can find this and can guide me?

Thanks!

[TimFun13]

Hey guys there isn’t much tutorials on how to find the recoil address. Can someone tell me how to find it?

I have scan for current bullets, shoot and scan again. I get the ammo value. Now I go into the memory view and mess around with the values and I just try find the recoil address but cannot find it at all? I managed to only find time in between shots and rapid fire. But no sight of recoil. Does anyone know where I can find this and can guide me?

Thanks!

1. You can find the x,y,z for the barrel (used for the angle/trajectory calculations) and see what writes to the y.

2. Get a full-auto gun and have a no reload hack enabled. Use speed hack to slow the game down. Then scan for a float unknown initial value; the continues fire and pause and scan for increased, stop firing scan for decreased value, and repeat; then freeze at low value and see if an address reduces or disables recoil. But often I find to completely remove recoil requires code injection, but you can still tend to see a reduction when freezing the right address.

[Learner]

I have tried doing step 1 by seeing what writes to the Y by shooting but no addresses come up. Don’t know why this is so hard to find....

[TimFun13]

You need to find the y coordinate or the guns pitch, if you can't freeze it and lock the weapons position it's not the right address.

There is also method 2.

[Learner]

You need to find the y coordinate or the guns pitch, if you can't freeze it and lock the weapons position it's not the right address.

There is also method 2.

The Y pitch is the axis that is up and down right? When I add the address and freeze it. I won’t be able to move mouse up and down, correct? If this is correct I then see what write to address and shoot once. Nothing pops up. Been trying many countless times cannot find it.....

[TimFun13]

...
The Y pitch is the axis that is up and down right? When I add the address and freeze it. I won’t be able to move mouse up and down, correct? If this is correct I then see what write to address and shoot once. Nothing pops up. Been trying many countless times cannot find it.....

[Link]

If it's changing, something should be writing to it.
Try a different debugger in the CE settings.
[Link]

[Learner]

Nah cannot find it with CE. Can someone try find it and let me know if u can find it. Game is Assault Cube 1.2